您当前的位置是:首页 >> 新闻动态 >>

渣浆泵在工作的时候如果出现故障一定要先找到是哪里出了问题
作者: 更新日期:2020-03-16 09:57 浏览次数:

渣浆泵在工作的时候如果出现故障一定要先找到是哪里出了问题,对症下药才能有正确的处理措施,一般情况下,可以参考下面的处理方法:

    1.涡壳内固硬沉积物淤塞,可采取清除淤塞物措施。

    2.如叶轮或进出水管路阻塞,可采取清洗叶轮或管路。如叶轮磨损严重,应采取更换 。 如填料口漏气,应压紧填料。输送高度过高,管内损失阻力过大,降低输送高度或减小阻力,针对这些故障原因。

    3.如轴与添料箱不同轴心,主要原因是加工误差大、安装不正确。应注意在安装后检查安装是否正确。 如密封水环磨损严重,需更换新水环。如密封清水管堵塞,密封水无法进入盘根中间造成盘根磨损快,导致漏料。应对堵塞水管进行疏通,保持密封水清洁

When the slurry pump is working, if there is any fault, it is necessary to find out the problem first, and then correct treatment measures can be taken. In general, the following treatment methods can be referred to:
1. If the solid hard sediment in the volute is silted, measures can be taken to remove the silting.
2. If the impeller or water inlet and outlet pipes are blocked, clean the impeller or pipes. If the impeller is seriously worn, it shall be replaced. In case of air leakage at the packing port, the packing shall be compacted. The conveying height is too high, the loss resistance in the pipe is too large, and the conveying height is reduced or the resistance is reduced.
3. If the axis is different from the feeding box, the main reason is the large processing error and incorrect installation. Pay attention to check whether the installation is correct after installation. If the seal water ring is seriously worn, replace it with a new one. If the seal water pipe is blocked, the seal water cannot enter the middle of the packing, resulting in quick packing wear and material leakage. The blocked water pipe shall be dredged to keep the sealing water clean